BARD W24AB-A10-2 Ton 11 EER Wall Mount AC-230V-1PH-10KW Electric Heat

Description

BARD W24AB-A10-2 Ton 11 EER Wall Mount AC-230V-1PH-10KW Electric Heat
74" x 33" x 18", New In Original Packaging
The Bard Wall-Mount Air Conditioner is a self contained energy efficient heating and cooling system, which is designed to offer maximum indoor comfort at a minimal cost without using valuable indoor floor space or outside ground space. These units are the ideal products for versatile applications such as: new construction, modular offices, school modernization, telecommunication structures, portable structures or correctional facilities. Factory or field installed accessories are available to meet specific job requirements.
Engineered Features:
Aluminum Finned Copper Coils Rifled tubing and enhanced louvered fin for maximum heat transfer and energy efficiency.
Quiet Twin Blowers: Designed to accept full ducted system or for non-ducted free blow installations.
Air Conditioner Compressor: Scroll Compressors eliminate need or crankcase heater. Standard on all models.
Designed with R-410A (HFC) non-ozone depleting refrigerant in compliance with the Montreal protocol and 2010 EPA requirements.
Liquid Line Filter Drier: Standard on all units. Protects system against moisture.
Galvanized 20 Gauge Zinc Coated Steel Cabinet: Cleaned, rinsed, sealed and dried before the polyurethane primer is applied. The cabinet is handsomely finished with a baked on textured enamel, which allows it to withstand 1000 hours of salt spray tests per ASTM B117-03.
Electric Heat Strips: Features an automatic limit and thermal cut-off safety control. 10 kw Heater package factory  installed.
Filter Service Door: Separate service door provides easy access for filter change.
One Inch, Disposable Air Filters: Are standard equipment. Optional one inch washable filters available and filter racks permit the addition of 2" pleated filter. Factory or field installed.
Condenser Fan and Motor Shroud Assembly: Slides out for easy access.
Barometric Fresh Air Damper: Standard on all units. Allows up to 25% outside fresh air. Optional ventilation packages available.
Built-in Circuit Breakers: Standard on all electric heat versions of single (230/208 volt) and three phase (230/208 volt) equipment. Toggle disconnects are standard on all electric heat versions of three phase (460 volt) equipment.
Top Rain Flashing: Standard feature on all models.
Slope Top: Standard feature for water run-off.
Compressor Control Module: Standard on all units. Built-in off- delay timer adjustable from 30 seconds to 5-minutes. 2-minute on-delay if power interrupt. 120-second bypass for low pressure control, and both soft and manual lockouts for high and low pressure controls.
Alarm output for alarm relay.
High & Low Pressure Switches are Auto-Reset: Standard on all units. Built-in lockout circuit resets from the room thermostat. Provides commercial quality protection to the compressor.
Barometric Fresh Air Damper: Allows up to 100 CFM of fresh air.
Full Length Mounting Flanges: Built into cabinet for improved appearance and easy installation.